Manufacturer-independent functional testing of flowmeters in sewer system and wastewater treatment plants

Application Report | Water & Wastewater

  • Reliable compliance with verification cycles in accordance with Self-Monitoring Ordinance
  • Verification of all electromagnetic flowmeters, including documentation
  • Reduced administrative cost: only one service partner takes care of all device testing, regardless of manufacturer
Manufacturer-independent functional testing of flowmeters in sewer system and wastewater treatment plants

Veolia Wasser Deutschland GmbH operates several wastewater treatment plants in the German federal state of Saxony-Anhalt. Among them is the Schönebeck wastewater treatment plant, which treats wastewater from approximately 90,000 residents. In order to guarantee the steps required for treatment at this and other smaller wastewater treatment plants operated in the municipal area, the company makes use of both measuring solutions and a number of electromagnetic flowmeters (EMF) from different manufacturers. These measuring devices are subject to the applicable Self-Monitoring Ordinance in place in the state of Saxony-Anhalt. The Self-Monitoring Ordinance requires operators of every wastewater treatment plant to test the measuring technology on an annual basis.

Measurement requirements

As wastewater treatment falls legally under state jurisdiction, each state has its own ordinance. For this reason, the monitoring cycles may vary. One of the legal requirements in water management has always been to accurately track and document wastewater quantities. To this end, proper and accurate flow measurement is a must. Regular testing by a service technician guarantees compliance with legal requirements the entire time a measuring device is in use. Field-tested verification tools and approved comparative measurements followed by the issuing of a test certificate ensure that the monitoring is sufficiently documented. This applies regardless of manufacturer, which is particularly important to the wastewater treatment operator because, for historical reasons, the facility uses many different flowmeters from different manufacturers. In the operator's catchment area there are 13 flowmeters subject to legally required testing. Only four of these devices are KROHNE EMF. The rest are competitors' devices.

KROHNE Solution

The customer commissioned KROHNE to test all of the flowmeters in the municipal area. KROHNE's service department specialises in these legally required tests in addition to numerous other services. A service technician tests all of the flowmeters in the wastewater treatment plants at the prescribed intervals to ensure that they are operating properly and records the results. In the process, the technician also checks signal output function and makes sure that each device is set properly. The technician also carries out a comparative measurement independent of the measuring principle. This all takes place without process interruption. There is no need for pipes to be opened or removed. The service technician uses a portable, battery-powered ultrasonic clamp-on flowmeter to test all common nominal sizes – from DN15 to DN1500. It goes without saying that the service technician complies with all required safety standards while performing this work.

Customer benefits

In the past, the operator had to call on service technicians from a variety of manufacturers. Different contact people and a wide variety of price models resulted in significant administrative cost. Today, the operator enjoys a much leaner process. For a guaranteed period of five years, KROHNE will test the measuring devices – regardless of manufacturer and with fixed annual terms and conditions. This increases process efficiency and decreases the amount of organisational effort on the part of the customer. Hiring KROHNE has made it quick and easy for the customer to exploit untapped optimisation potential at the facility.